rigidness
英
美
网络 刚度; 僵化; 烧火棍管的刚度
英英释义
noun
- the quality of being rigid and rigorously severe
- the physical property of being stiff and resisting bending
双语例句
- As far as English-Chinese translation is concerned, the translation of relative clause is not only important but also difficult, and it is mainly responsible for the rigidness of most translation.
就英译汉而论，定语从句的翻译既是重点又是难点，大凡译文之生硬、拗口甚至晦涩多半与没能译好关系从句有关。 - By comparing static and kinetic rigidity with some examples, measures of raising the kinetic rigidness of tools are suggested.
通过动、静刚度的对比和一些实例，得出了提高机床动刚度的措施。 - The drawback of this model is likely to cause the rigidness and excellence of the teaching construction system, which is difficult to mobilize the initiative and interoperability of teachers more broadly.
这种模式的弊端是容易造成高校的教学建设体系过于墨守成规与精英式，无法更广泛地调动教师的积极性和协作性。 - Carbon fiber has being used widely in reinforcement of concrete structure due to the properties of its high specific strength, specific rigidness, better anti-erosive, and the new technology of concrete bridge reinforcement using carbon fiber is being set up gradually.
碳纤维以其具有极好的比强度和比刚度，优秀的耐腐蚀性已广泛用于混凝土结构的粘贴加固工程，并已逐步形成了碳纤维加固混凝土桥梁的新技术。 - Directing against the operating condition and tubulature stress calculation, a technical scheme for remedy of the said vibration has been worked out, to install vibration damper for enhancing the rigidness of said pipeline.
针对运行工况和管系应力计算，制定了加设减振装置，提高管系刚度的振动治理技术方案，治理后管系振动明显降低。 - For this reason, the present paper, according to the strength rigidness requirements and stable limit of bearing capacity of compression bar, the notched height of reinforced concrete tower building can be calculated.
为此，本文根据压杆的强度、刚度要求和稳定承载能力极限，应用钢结构设计原理，计算钢筋混凝土高耸建筑物的切口高度。 - T beam horizontal laying calculation method based upon rigidness correction
基于刚度修正的T梁横向分布计算方法 - Special fixture is used in turning process to keep the workpiece firmly and obtain necessary rigidness.
车加工工序采用专用夹具，使工件装夹牢靠，完全杜绝飞件现象，同时可保证加工中所需刚度，使工件加工精度和合格率提高。 - ⑵ Typical working conditions analysis: In the bases of FEA model, this paper analyzed bus-body structure under three typical working conditions, and checked its strength and rigidness of top-body frame.
⑵在大客车车身结构有限元模型基础上，对车身及顶部骨架结构进行了弯曲、扭转及紧急制动三种典型工况下的结构分析，并校核了其刚度和强度。 - Based on'reduced section ', the thesis develops a method to rectify the strength and rigidness of the main bearing components in which an example is illustrated.
前言：提出了以“折算截面”为基础，对玻璃钢复合材料梯子间主要受力构件进行强度和刚度校核的力学计算方法，通过实例进行了介绍分析。