short-circuiting

英 [ˌʃɔːt ˈsɜːkɪtɪŋ]

美 [ˌʃɔːrt ˈsɜːrkɪtɪŋ]

v.  (使)短路; (做事)抄近路，走捷径
short-circuit的现在分词

柯林斯词典

• V-ERG (使)短路
  If an electrical deviceshort-circuitsor if someone or somethingshort-circuitsit, a wrong connection or damaged wire causes electricity to travel along the wrong route and damage the device.
  1. Carbon dust and oil build up in large motors and cause them to short-circuit...
     碳尘和燃油在大发动机里越积越多，造成了发动机短路。
  2. Once inside they short-circuited the electronic security.
     一旦置入，它们就会使电子安全设施短路。
  3. Short-circuitis also a noun.
     
  4. The fire was started by an electrical short-circuit.
     火灾是由电线短路引发的。
• VERB 回避，绕过（某一流程或程序)
  If someone or somethingshort-circuitsa process or system, they avoid long or difficult parts of it and use a quicker, more direct method to achieve their aim.
  1. The approach was intended to short-circuit normal complaints procedures.
     这种方法旨在避开正常的投诉程序。

双语例句

• Influence of dynamic electromagnetic force on stability of short-circuiting transfer in GMAW
  电磁力动态变化对短路过渡稳定性的影响
• The electrical field radiated by the unit current in a rectangular waveguide with a short-circuiting plunger is derived by making use of the auxiliary potential function.
  应用辅助势函数，推导了一端具有短路板的矩形直波导中单位电流源的辐射场。
• According to the analysis we can get the result of the welding quality from the current and voltage of the CO_2 gas shield droplet short-circuiting transfer.
  在此基础上，采用本系统对熔滴短路过渡CO2气体保护焊的焊接电流和电压波形进行了实时采集、存储。
• The control of CO 2 arc welding short-circuiting transfer with magnetic field is studied.
  研究了外加磁场对CO2焊短路过渡的控制。
• Randomicity& stability of short-circuiting droplet transfer in arc welding process
  弧焊短路过渡过程的随机性与稳定性
• Short-circuiting Effect and the Solution in Gnutella Network
  Gnutella网络中的短路效应及其解决方案
• The rule of the arc-time and short-circuiting transfer cycle time under the high speed welding was researched by welding quality analyzer of Hannover.
  采用汉诺威焊接质量分析仪，研究了在高速焊接的情况下，燃弧时间与短路过渡周期的变化规律。
• The Employer reserves the right to perform additional inspection of production welds made using GMAW in the short-circuiting transfer mode.
  业主保留对使用短路过渡模式下的gmaw的生产焊缝进行附加检验的权利。
• Computer simulation on arc welding short-circuiting transfer process and current waveform control
  弧焊短路过渡过程及其电流波形控制的计算机仿真
• If your program logic depends on any of that additional code, you should probably avoid short-circuiting operators.
  如果程序逻辑依赖于任何这些附加代码，您可能应该避免使用短路运算符。